In short
- First look at the transmission report: it says at which point things failed.
- The “Text” fax quality reduces the amount of data and shortens the transmission.
- A lower speed is less sensitive to interference.
- With SIP, T.38 transmits more robustly than G.711.
First read what the transmission report says
| Message | What is behind it |
|---|---|
| Busy | The remote station is sending or receiving at that moment. The program redials by itself. |
| No answer | Nobody picks up: the device is switched off or the number is wrong. |
| No fax machine | A person or an answering machine answers at that number. Check the number. |
| Broken off during transmission | The connection was established but was disturbed. This is where the settings below help. |
Three settings that usually help
Choose the “Text” fax quality
Photos and grey areas produce a lot of data and long transmissions. “Text” makes the page smaller and the fax shorter.
Lower the speed
Just 9,600 bit/s instead of 14,400 bit/s. That takes a little longer, but copes with interference considerably better.
With SIP: switch on T.38
If your provider supports it, T.38 transmits the fax data directly and is less susceptible than transmission as sound.
ECM error correction is switched on by default. Some older receiving devices cannot cope with it; in that case, Fritten&Fax tries once without it by itself.
If it is down to the remote station
If faxes fail only with one particular recipient, the cause usually lies there: an old device, a full memory, no paper or a connection with a poor line. As a cross-check, send a fax to a different number. If it arrives, your setup is fine – and a short call to the recipient clears up the rest.
If no connection is established at all
- Via the router: Is the interface switched on, and are the PC and the router on the same network? “Check” shows which step is missing.
- Via SIP: Is the program registered with the provider? Are the user name and password still correct?
- The number: Has it been entered in full, including the area code?